For any S-Chassis bar, the bar would depend on the BUMPER that you are using, not the chassis.The length of our jack points are designed based off of the OEM bumper height to keep it level, without protruding past the OEM bumper.The "Upper Support" option is only available for 180sx (pop-up).The "Corner Bracing" option is only available for S-Chassis platform.S30 bars are not guaranteed to fit perfectly due to chassis inconsistencies.R32/R33 rear bumper requires moderate trimming to clear the jack point.R32: If you have N1 vents, then you may need to trim the vents to clear our bash bars.Miata: We haven't test fit our NA rear bars on any NB's so we are unable to confirm if they are interchangeable or not.IS300 - Will work with JDM Altezza bumper.Genesis chassis' mounting points are too weak to support a jack point, so we only offer a basic version.FRS front bash bars only fit on the 2012-2016 models.280z bars are not guaranteed to fit perfectly due to chassis inconsistencies. ![]() ![]() AE86 bars come with universal bumper tabs that are not guaranteed to fit any specific bumpers.(Heat from welding the jack point causes the support arms to pull inward.) We recommend using a pry bar to assist with installation and a small amount of force to get the support arm to slide into the OEM mount. Bars with jack point: It is normal for our bash bars with jack points to be a tight fit upon installation.Using incorrect hardware may lead to damaging product. OEM hardware is required for the install. ![]() Bash bars have not been tested on every bumper, so some modification or trimming may be required.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |